Set Sensor Threshold 命令详情
更新时间：2025/06/26
在Gitcode上查看源码修订记录
| openUBMC版本号 | 修订日期 | 修订人 | 修订内容 |
|---|---|---|---|
| 25.06 | 2025/06/26 | pengqiang-gs | 初稿，新增命令详情 |
基本信息
功能说明
设置具体传感器的门限值。 This command is used to set the specified threshold for the given sensor.
权限
ReadOnly
命令信息
请求信息
| 字节顺序 | 域取值说明 |
|---|---|
| 1 | sensor number (FFh = reserved) |
| 2 | [7:6] - reserved. Write as 00b. [5] - 1b = set upper non-recoverable threshold [4] - 1b = set upper critical threshold [3] - 1b = set upper non-critical threshold [2] - 1b = set lower non-recoverable threshold [1] - 1b = set lower critical threshold [0] - 1b = set lower non-critical threshold |
| 3 | lower non-critical threshold. Ignored if bit 0 of byte 2 = 0 |
| 4 | lower critical threshold. Ignored if bit 1 of byte 2 = 0 |
| 5 | lower non-recoverable threshold. Ignored if bit 2 of byte 2 = 0 |
| 6 | upper non-critical threshold. Ignored if bit 3 of byte 2 = 0 |
| 7 | upper critical threshold value. Ignored if bit 4 of byte 2 = 0 |
| 8 | upper non-recoverable threshold value. Ignored if bit 5 of byte 2 = 0 |
响应信息
| 字节顺序 | 域取值说明 |
|---|---|
| 1 | Completion Code. |
命令样例
样例1：
- 请求：
- 响应：