Deactivate Payload 命令详情
更新时间：2025/06/26
在Gitcode上查看源码修订记录
| openUBMC版本号 | 修订日期 | 修订人 | 修订内容 |
|---|---|---|---|
| 25.06 | 2025/06/26 | pengqiang-gs | 初稿，新增命令详情 |
基本信息
功能说明
标准命令，结束一个IPMI会话的负载类型。当前命令仅用于 RMCP 会话。 This command is used to terminate use of a given payload on an IPMI session.
权限
KvmMgmt
命令信息
请求信息
| 字节顺序 | 域取值说明 |
|---|---|
| 1 | [7:6] - reserved [5:0] - payload type(See Payload Type Numbers). |
| 2 | Payload Instance [7:4] - reserved [3:0] - payload instance. 1-based. 0h = reserved. |
| 3:6 | Auxiliary Request Data. Additional payload-specific parameters to configure behavior of the payload when it becomes activated. Ignored if no auxiliary data is specified for given payload type. For Payload Type = SOL:: (no auxiliary data) write as 0000_0000h |
响应信息
| 字节顺序 | 域取值说明 |
|---|---|
| 1 | Completion Code Generic plus the following command-specific completion codes: (An error completion code should be returned if the payload type in the request is set to “IPMI Message” ( 0h ) ). 80h: Payload already deactivated. 81h: Payload type is disabled (optional). Given payload type is not configured to be enabled for activation. |
| 12:13 | Payload VLAN Number - FFFFh if VLAN addressing is not used. |
命令样例
样例1：结束一个IPMI会话的负载类型
- 请求：
- 响应：