Set User Payload Access
更新时间： 2025/06/26
在AtomGit上查看源码4Ch-设置用户有效载荷访问（Set-User-Payload-Access）
修订记录
| openUBMC版本号 | 修订日期 | 修订内容 |
|---|---|---|
| 25.06 | 2025/06/26 | 初稿，新增命令详情 |
基本信息
功能说明
设置用户有效载荷访问。
权限
命令信息
请求信息
| 字节顺序 | 域取值说明 |
|---|---|
| NetFn | App 06h |
| CMD | 4Ch |
| 1 | Channel Number [7:4]-reserved [3:0]-Channel Number |
| 2 | [7:6]-Operation 00b=ENABLE. Writing a "1b" to enable/disable bit ENABLES corresponding payload. Writing "0b" to bit causes no change to enabled/disabled state 01b=DISABLE. Writing a "1b" to bit DISABLES corresponding payload. Writing 0b to bit causes no change to enabled/disabled state 10b, 11b=reserved [5:0]-User ID, 000000b=reserved |
| 3 | Standard Payload enables 1 [7:2]-reserved for standard payloads 2-7 enable/disable bits [1]-standard payload 1 (SOL) enable/disable [0]-reserved, Note: IPMI Messsaging is enabled/disabled for users via the Set User Access command |
| 4 | Standard Payload Enables 2-reserved |
| 5 | OEM Payload Enables 1 [7]-OEM Payload 7 enable/disable [6]-OEM Payload 6 enable/disable [5]-OEM Payload 5 enable/disable [4]-OEM Payload 4 enable/disable [3]-OEM Payload 3 enable/disable [2]-OEM Payload 2 enable/disable [1]-OEM Payload 1 enable/disable [0]-OEM Payload 0 enable/disable |
| 6 | OEM Payload Enables 2-reserved |
响应信息
| 字节顺序 | 域取值说明 |
|---|---|
| 1 | Completion Code Note: an implementation will not return an error completion code if the user access level is set higher than the privilege limit for a given channel. If it is desired to bring attention to this condition, it is up to software to check the channel privilege limits set using the Set Channel Access command and provide notification of any mismatch |
命令样例
设置用户有效载荷访问
请求：
ipmicmd -k "0f 00 06 4c 01 02 02 00 00 00" smi 0响应：
0f 07 00 4c 00说明：本例响应的完成码为 00（成功）。为通道 1 上的用户 2 启用 SOL 载荷访问；其余载荷使能位不变，保留字节填 00h。