Set Lpar DFT config
更新时间： 2026/08/06
在AtomGit上查看源码Set Lpar DFT config
Change History
| openUBMC Version | Revision Date | Description |
|---|---|---|
| 25.06 | 2025/06/26 | Initial draft: add command details |
Basic Information
Function Description
Sets the Lpar DFT configuration.
Privilege
Command Information
Request Information
| Byte | Data Field |
|---|---|
| NetFn | 30h |
| CMD | 97h |
| 1:3 | Manufacturer ID, LS Byte first. The length is fixed to three bytes. For example, if the vendor ID is 2011 and the corresponding hexadecimal value is 0x0007DB, the first byte is DBh, the second byte is 07h, and the third byte is 00h. |
| 4 | Sub command. The sub command is 0eh. |
| 5 | Configuration Type 00h=Logical Partition Boot Option 01h=Equipment mode |
| 6:N | Configuration parameter data. For details, see Table 1. |
Response Information
| Byte | Data Field |
|---|---|
| 1 | Completion Code 80h=parameter not supported. 81h=attempt to set the 'set in progress' value (in parameter #0) when not in the 'set complete' state. (This completion code provides a way to recognize that another party has already 'claimed' the parameters) 82h=attempt to write read-only parameter |
| 2:4 | Manufacturer ID, LS Byte first. The length is fixed to three bytes. For example, if the vendor ID is 2011 and the corresponding hexadecimal value is 0x0007DB, the first byte is DBh, the second byte is 07h, and the third byte is 00h. |
Reference Information
Table 1 set Lpar dft config response
| Parameter | Parameter Data | configuration type | |
|---|---|---|---|
| lpar setup config | write-only | 00h Logical partition startup shutdown 01h: logical partition startup enabled | 0 |
| lpar dft mode config | write-only | 00h: The equipment mode is disabled. 01h: The equipment mode is enabled. | 1 |
Command Example
Set the Lpar DFT configuration.
Request:
bash
ipmicmd -k "0f 00 MM NN" smi 0Response:
text
0f MM NN